Remote Control and Telemetry

Station Hub - I / O Interface to SNMP

Every device that has an interface with Telesignals / remote controls can be connected to a station hub that communicates with a REMOTE I / O card to TCP / IP / SNMP that translates parallel contracts in the SNMP OID for management via CTE BLUE Broadcast NMS. In An indefinite number of interfaces can be installed on each workstation that can communicate with each other in TCP / IP or through the CAN BUS series bus, bringing in the inputs / outputs or their OID equivalents to a Almost infinite number.

Connections to remote surveillance devices

It can be done through a convenient terminal board. This interface converts any type of digital or analog input / output signal into a TCP / IP and web-based SNMP protocol
Thanks to RS232, RS485, Can Bus or I2C interfaces, it is easy implement a custom protocol to convert from any proprietary protocol to a standard TCP / IP-SNMP protocol or simply to transport any proprietary protocol through an IP interface.
The REMOTE I / O to TCP / IP / SNMP tab has the following characteristics:

• 8 optoisolated digital inputs
• 8 optoisolated digital outputs
• 8 galvanically isolated analog inputs
• 2 galvanically isolated analogue outputs
• 2 canned bus ports
• 1 USB port
• 1 RS232 serial interface
• 2 RS485 serial interfaces
• 1 I2C interface
• Automatic IP recovery for easy search on the network
• 3 status LEDs
• TCP / IP protocol
• SNMP V1 / V2 protocol
• SMTP protocol (send and receive emails)
• Built-in web page with easy to customize JSON based file configuration
• Built in MIB file easy to customize
• Fully HTML5 compatible GUI, no JAVA required for the browser